How-to: Receive Acceleration Snippets
=====================================

This example outlines the steps to connects to an ANURA vibration
sensor and configures it to send acceleration waveform data in the form of
snippets.

1. **Scan for the Device**:
   Scan to find the sensor node, which will be advertising the AVSS UUID.
2. **Connect and Subscribe**:
   Connect to the sensor and set up subscriptions to the Control Point and
   Report characteristics.
3. **Retrieve Firmware Info**:
   Execute the ``Get Firmware Info`` command and note the response. Although
   not mandatory, displaying this information can be useful for troubleshooting.
4. **Configure Settings**:
   Execute the ``Write Settings`` command and await the response. The sensor
   will ignore any unknown or malformed parameters, and the response will
   indicate the number of ignored parameters.
5. **Apply Settings**:
   Execute the ``Apply Settings`` command and await the response. If the sensor
   needs to reboot, the ``will_reboot`` parameter will be set. The client
   should handle this by reconnecting.
6. **Subscribe to Snippet Reports**:
   Execute the ``Report Snippets`` command to subscribe to snippet reports.
7. **Trigger Measurements**:
   Send a ``Trigger Measurement`` command to initiate measurements, even if the
   sensor is stationary. To extend the measurement period beyond the maximum of
   60 seconds, issue repeated ``Trigger Measurement`` commands. These can be
   sent before the previous measurement period has ended.